Jump to content

76/45 suppressor take down


Recommended Posts

Trying to disessemble my Stemple 76/45 for cleaning. Removed both set screws, remove the end cap and it looks like the spanner wrench loosens the "washer assembly" but slides out 3/4" of an inch. I can push the body back and fourth but that's it. Not sure if I have to remove the screw on bbl and bushing?

Link to comment
Share on other sites

  • 3 weeks later...

From what I understand, You are supposed to take the suppressor apart and clean at about every 100 Rds. I can put 500 rounds thru a suppressed MG in an afternoon. Carbon builds up and the baffles do not come out without a lot of work. I just shoot them until performance is unsatisfactory, Then send them off to the MFG for repair/cleaning.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...