Rjs Guns Posted February 24, 2020 Report Share Posted February 24, 2020 Hello Im wanting to build a M11 in 9mm or 45acp smg and need parts kit, plates, basically everything. Anyone have anything? Thanks Quote Link to comment Share on other sites More sharing options...
Pyrocoyote Posted February 26, 2020 Report Share Posted February 26, 2020 You would be better off buying a semi and using the receiver to convert it to sub gun than building from scratch. Much easier. But Leetool has side plates for building them on this site in parts. My two cents worth. 1 Quote Link to comment Share on other sites More sharing options...
Rjs Guns Posted February 27, 2020 Author Report Share Posted February 27, 2020 16 hours ago, Pyrocoyote said: You would be better off buying a semi and using the receiver to convert it to sub gun than building from scratch. Much easier. But Leetool has side plates for building them on this site in parts. My two cents worth. Thanks for the reply.. I was thinking about that. I saw a lower for sale on gunbroker. I know i would have to remove the internals and drill a hole. Just not sure if the existing holes would be the same. Plus i would have hole i wouldnt be using where the selector goes. thanks again Quote Link to comment Share on other sites More sharing options...
Pyrocoyote Posted February 28, 2020 Report Share Posted February 28, 2020 Very easy to weld up and grind of and sand to finish.Then spot weld the sear anchor pin in the front flat side of lower. Easy to build. Lower safety is the same place as subgun. Quote Link to comment Share on other sites More sharing options...
Rjs Guns Posted February 29, 2020 Author Report Share Posted February 29, 2020 19 hours ago, Pyrocoyote said: Very easy to weld up and grind of and sand to finish.Then spot weld the sear anchor pin in the front flat side of lower. Easy to build. Lower safety is the same place as subgun. ok just kinda looking at options. I appreciate your input thanks Quote Link to comment Share on other sites More sharing options...
Pyrocoyote Posted February 29, 2020 Report Share Posted February 29, 2020 You can also buy one of the side plates for selector hole placement. To mark the semi receiver. Good luck. You can do It!! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.