Trade pending: BAR 1918A2 (amazing condition) with a large parts lot too.

[KickStand]

 ***Trade pending*** if it falls through, I’ll update the listing. Thanks for all the interest and this Forum.
 

Reduced, open to out of State sales and open to trades (plus cash).

Up for sale, is a fantastic condition transferable ERMCO Browning Automatic Rifle with a large parts lot.

This BAR M1918A2 model, is one of the very few ERMCO builds on the market. EMRCO made an extremely limited number of these, I believe around 60 (this gun has an extremely low serial number). The ERMCO guns were made to highest quality possible and it’s evident with their receivers. Unlike other manufacturers that used cast receivers, ERMCO’s were made out of a solid 35 pound block of High-Quality Ordnance Steel and then machined down, to the approximately 4 pound receiver. Renowned for their overall build quality, one-piece receivers, and the attention to detail, while being built under E.R. “Pony” Maples from RAMO. ERMCO, was a subsidiary of RAMO, Inc. (Defense contractor, who made numerous military machine guns).

Spare Parts: Also, this gun will come with a huge parts/magazine lot. Too many parts to list but I tried (apologies, if any of the parts name are incorrect), pictures are attached. I’ll update some more of the parts; that’s in the bags too. 

Condition: According to my late friend, this gun was only fired one time (20 rounds), and I haven't even shot it yet. You’d be hard pressed to find one with less rounds through it and its condition shows. Other than a few safe marks, it’s in amazing condition.

Price: The price for the gun and the entire parts/magazine lot is $36,000 (No taxes, private sale, payment details will be discussed privately).
This gun is located in Florida, on a Form 4. Willing to Sell/Trade out of State now. Shipping will be Via USPS Registered Mail with an Apple AirTag inside a Pelican case, that I'll provide. My last out of state Form 4 transfer to a dealer, took approximately 35 days. For the moment, this gun is going to be for sale, in-state only. Yes, I’m aware that this will greatly reduce the pool of potential buyers and I might open it to other states, if I can’t sell it. This will help to eliminate the scammers and give the potential buyer, the opportunity to inspect the gun/paperwork for themselves. If a deal is made, I’d be willing to let the buyer test fire the gun at my property, if they choose to. Furthermore, the buyer will be aware of its condition, and it’ll be sold as is, with no warranty. I work in the law enforcement field and can provide credentials, if need be. For more feedback, check my Uzitalk profile, same username.

Trade, plus cash: Open to Trades but I’d need to receiver your part of the deal, before I make the transfer. With an in-state sale, this shouldn't be a problem (I refuse to be scammed and so should you). This was a gun that I planned on passing down and have gone back and forth about selling it. I’ve come to the conclusion, that this is a gun that I won’t shoot and therefore, I’ve decided to sell (I’m more into Sub Guns).

Cross Posted: Posted on UziTalk too.

Pics below (more pictures and videos, in 4K can be sent, privately). I’m not posting too many pictures publicly, due to all scammers.

 

 

 

20 mags wrapped in cosmoline.

 

Box full of parts, some with a lot of cosmoline (appears to be a complete bolt group in cosmoline, operating handle, rear sight, buffer tube, buffer parts, sling swivel, trigger, and a lot of other misc. parts).

 

Broken shell extractor

 

Gas tube with gas regulator, heat shield and wood forend

 

Spare bipod

 

slide and NOS gas piston

 

2 trigger housings and not sure what other parts is.

 
 

2 flash-hiders and a adjustable gas regulator.

 

 

Misc. parts and firing pin  

 

Appears to be a complete front sight.

 

springs and actuator tube.

 

Bag full of parts (I’ll look into the bag and see what the contents are and update the listing). 

 

Spare carry handle

 

Spare stock

5 Like new mags and a tool

 

Excerpt from “Full Auto magazine”  

Edited July 23, 2025 by KickStand
updated ad

[KickStand]

Listing price has been reduced. Also, I'm Open to out of State sales / trades.

My last Form 4 to an out of State dealer, took approximately 35 days.

 

BTT

[KickStand]

Bump.