Cryostructure Posted May 19, 2024 Report Share Posted May 19, 2024 We have a new 3rd hole jig that works on BOTH sides of the lower. Past ones only worked on one side which could cause problems and you would need a drill press to accurately guide the pin & it was the only complaint with that past with this type of jig. With ours you just need a standard hand drill to drill both sides. This is a new design that we have feedback from. Hardened drill bushings for a lifetime of accurate surface. Aluminum with hardened pressed fit steel bushings and pins. Just contact us, but we will have you send us a copy of your FFL & SOT. We will only ship to the addresses on the FFL& SOT license, but you can have more than one jig. $50 each with $8.95 flat shipping. https://www.cryostructure.com/product/sot-micro-jigs/ Link to comment Share on other sites More sharing options...
Recommended Posts