Posted 5 Oct 2016 Looking to buy an M11A1/.380 MAC, SWD upper receiver with or without bolt. Also looking for an original wire stock. Please PM me on here. Butler, Pennsylvania, United States Share this post Link to post Share on other sites
Posted 9 Oct 2016 HOWDY ! try www.ftfindustries.com or cobray@cobray.com . cobray only has double loop butt wire forms available for the M11/9 that will also fit the M11/380 model as far as the rail length goes.I have a few single loop butts with out the rails for trade or sale. Good day!! Share this post Link to post Share on other sites
Posted 9 Oct 2016 Thanks for the reply and information. I just bought an M11/Nine stock really cheap. I don't have it yet, but I assume it will stick out a couple of inches on the M11A1, since the M11/Nine lower is two inches longer. Share this post Link to post Share on other sites
Posted 3 Dec 2016 (edited) @ misterglockSir the M11 9 stock will fit and you can make it fit correctly with a little finesse with a end mill to make new slots for the catch. Also not all m11 A1's are created equal. Some parts like bolts and uppers mixed may cause headspace problems and FTF or dangerous condition. Example- a SWD m11-A1 bolt most likely in a RPB or overstamp upper will smash your shell so hard it may cause pressure problems from not enough headspace. Conversely a RPB bolt in a SWD gun will cause a lot of FTF due to too much headspace. An aftermarket bolt ALWAYS need work.. for safety and reliability. My suggestion is do not mix manufacturers unless a gunsmith headspaces the gun properly. Edited 3 Dec 2016 by mstrmstr Share this post Link to post Share on other sites