Heman Posted August 29, 2021 Report Share Posted August 29, 2021 Hello, I'm a new type 07/02 and looking at form 02ing my first machine gun. Question I have is which would be the better way to go about it. Doing the 3rd hole or making a DIAS where it is registered as the MG. The second way appeals to me a little more so that way the lower itself isn't registered, but then wasn't sure how hard it is to time them, etc. Any suggestions or advice is appreciated. Thanks in advance, Quote Link to comment Share on other sites More sharing options...
notso Posted August 30, 2021 Report Share Posted August 30, 2021 Ive done both, and I prefer the drop in. Its more work to make and tune, but I ended up preferring it in the long run. Quote Link to comment Share on other sites More sharing options...
Heman Posted August 30, 2021 Author Report Share Posted August 30, 2021 Thanks for the reply why did you prefer the DIAS? I've got the metal to start making one. Also as far as tuning am I moving fore and aft or up and down? Wish there was a you tube video. Quote Link to comment Share on other sites More sharing options...
taylorwso Posted August 31, 2021 Report Share Posted August 31, 2021 jig + hole= MG in 30 seconds, unless you have to mill the lower. dias can be a pita to time and you have to mill it out. Quote Link to comment Share on other sites More sharing options...
Delta-10 Posted September 2, 2021 Report Share Posted September 2, 2021 This should help you figure out how to make your DIAS work http://www.quarterbore.com/nfa/dias.html Quote Link to comment Share on other sites More sharing options...
Heman Posted September 2, 2021 Author Report Share Posted September 2, 2021 Thank you very much, what size spring are they using? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.