Heman

New Type07/02 a question

Location:

6 posts in this topic

Hello,

I'm a new type 07/02 and looking at form 02ing my first machine gun.  Question I have is which would be the better way to go about it.  Doing the 3rd hole or making a DIAS where it is registered as the MG.

The second way appeals to me a little more so that way the lower itself isn't registered, but then wasn't sure how hard it is to time them, etc.  

Any suggestions or advice is appreciated.  

Thanks in advance,

 

Share this post


Link to post
Share on other sites

Ive done both, and I prefer the drop in. Its more work to make and tune, but I ended up preferring it in the long run. 

Share this post


Link to post
Share on other sites

Thanks for the reply why did you prefer the DIAS?  I've got the metal to  start making one.  

Also as far as tuning am I moving fore and aft or up and down?  Wish there was a you tube video.  

Share this post


Link to post
Share on other sites

jig + hole= MG in 30 seconds, unless you have to mill the lower.

dias can be a pita to time and you have to mill it out.

Share this post


Link to post
Share on other sites

Thank you very much, what size spring are they using?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now