Sign in to follow this  
Followers 0

WTB: (Breech/Receiver Side) 90* Barrel Facing Cutter for .44 or .45 Revolver

Location: Dayton

1 post in this topic

I am looking for a 90 degree barrel facing cutter, preferably for a Brownell's type hand tool, for a .44 revolver. This would be used to cut the breech gap for a new replacement barrel as opposed to a cutter used for muzzle facing. A cutter for a .45 would work just as well I'd think. I've considered the muzzle facing cutters that I've seen available, but most are too long to fit within the cylinder block of the revolver frame.

If you'd also have a steel or brass pilot guide in .44, I'm interested in that as well.



Edited by samorgan

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  
Followers 0