Rodney's Distributors

WTS: M1 M10 Combo Tool works GREAT for M1/M1A/M14 in-rifle bolt dis-assembly. VIDEO

Location: Parts and Accessories Market Board

1 post in this topic

M1 M10 Combo Tool works GREAT for M1/M1A/M14 in-rifle bolt dis-assembly. VIDEO

M1 M10 Combo Tool works GREAT for M1/M1A/M14 in-rifle bolt dis-assembly. Three available $11 each shipped or LAST TWO $16 shipped.
To use the M10 tool, screw a cleaning rod section in the hole on the handle. 
Put the screwdriver end into the chamber with the lug pointing up and the handle section to the right.
Ease the bolt closed and push it forward to compress the ejector.
Put your thumb over the extractor to restrain it and gently lift up on the cleaning rod section.
The lug on the M10 tool will push the extractor up and out of the bolt.
The firing pin will drop out the rear of the bolt.
Ease back on the op rod and remove the ejector and spring.

To reassemble.
Put the ejector and spring in the bolt.
Put the firing pin in the bolt.
With the M10 handle in the chamber, ease the bolt forward and push the op rod forward to compress the ejector.
Put the extractor spring and plunger in the bolt and push the ejector into the bolt.

VIDEO: TOP COMBO TOOL SOLD

IMG_2012.JPG

Edited by Rodney's Distributors

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.