MG Dave

Lieutenant
  • Content count

    22
  • Joined

  • Last visited

  • Country

    United States

Community Reputation

4 Neutral

About MG Dave

  • Rank
    Active Duty

Personal Information

  • City and State College Park, MD
  1. Two (2) MAC-10 45acp 10 round mags. One is stamped with the Cobray Logo, the other is not. $100 for the pair plus shipping.
  2. Found this in a box that was stored for over 25 years. Unsure of manufacturer. Looks used. What you see in the pic shipped for $375.
  3. Israel IMI UZI factory .45 cal 16 round mags for $175 ea. Only one left.
  4. WTS: LaFrance Specialties FAL

    Heath, I just posted three new pics. Two showing Left Side of Receiver. Contact me at SMGDave@yahoo.com with any other questions. Thanks, Dave
  5. Maxim 1910 smooth Spade Grips. Missing a few parts. What you see in pic for $250. Thanks, Dave
  6. Transferable LaFrance Specialties FAL registered receiver, 7.62mm cal with two (2) 20 rd mags. Buyer pays tax stamp out, shipping and insurance at actual cost. Can transfer to a Maryland resident directly with no dealer needed. All NFA rules apply. On form 4 in MD. $19K Any questions contact me at SMGDave@yahoo.com
  7. Two new M3 Grease Gun Cocking Assy's that are still new in the cosmoline. One (1) shipped for $165 or buy both shipped for $300. Thanks, Dave
  8. Need ID help on Spade Grip

    Aaron, Well it looks like the general consensus is that the spade grip is a Maxim grip. I was thrown be the wooden grips being smooth. Any idea the value of what I have ? Thanks to all in advance, Dave
  9. Need ID help on Spade Grip

    Aren, Not the Dave from Sarco your looking for. For 25+ yrs I've posted as MG Dave, I know Dave at Sarco and know he goes by MG Dave, but I don't think I've ever seen him post on Sturm as such.
  10. WTS: RIA M-60

    Transferable RIA standard config M-60. Owned since 1997. Factory RIA installed feed chute mounting bracket that can be used to attach flex chute or hanging a ammo box. RIA made 100 rd hanging ammo box. Buyer pays all taxes, shipping and insurance. $54K On a form 4 in Maryland. Can transfer direct, no dealer needed, person to person if in Maryland. All NFA rules apply. Any questions contact me at: SMGDave@yahoo.com
  11. Extremely rare British C&R metal stamped/wrapped Sten Mark II (not made from a tube. Only 1/2 of one percent of these wrapped Stens II's were made and most were destroyed in mid 1943. ATF shows manufacture as " British Government ". First appeared in the NFA registry on 02/1959. Mag well is stamped with serial number. Buyer pays all taxes, shipping and insurance. $9900. On a form 4 in Maryland. Can transfer direct, no dealer needed, person to person if in Maryland. All NFA rules apply. Any questions contact me at: SMGDave@yahoo.com
  12. UZI sear with host is SOLD. Thanks to all that replied. Dave
  13. WTS: WWII M1 TSMG (SOLD)

    Thompson M1 is SOLD, Thanks, Andrew
  14. WTS: WWII M1 TSMG (SOLD)

    C&R WWII SAVAGE M1 THOMPSON SMG $20k -- SOLD -- Transferable WWII C&R Savage manufactured M1 Thompson SMG. Most likely the first month production run of Savage made M1's in July 1942. Gun has been reparked and shows metal wear. The lower/trigger group frame has the proper Savage-produced "FULL AUTO" written in two lines, while on the Bridgeport lowers are marked in all on one line. Rear sight been updated to the later "protected" triangular guard winged rear L sight. Horizontal foregrip is Savage marked. Upper receiver stamped 'S' Stick-type fire control levers. Up graded reinforced cross-bolt in rear stock. Correct Savage stamped bright bolt. Two "GEG" civilian inspector Auto-Ordanace George E. Goll stamps, "R.L.B." Army inspector of Ordnance Colonel Ray L. Bowlin stamped and Crossed Cannon stamped. Paperwork shows manufacture as "SAVAGE". Serial # is 45925. TSMG M1 comes with one 30 rd mag. Buyer pays tax stamp out, shipping and insurance at actual cost. Can transfer to a Maryland resident directly with no dealer needed. All NFA rules apply. On form 4 in MD. $20K Any questions on the FAL or M1 e-mail me : SMGDave@yahoo.com
  15. Need help to ID these spade grips. Don't think it's to a Vickers, Maybe Russian ?